Backer Marathon Call Us Today 1-830-775-1417
  1. Home
  2. Cartridge Heaters
  3. Non-Swaged Cartridge Heaters
Non Swaged Heater
Standard Construction Non Swaged Heater
Non Swaged Heater With 3 Zone Construction
Non Swaged Heater With 3 Zone Construction
Non Swaged Heater With Brass NPT
Non Swaged Heater With Epoxylite Potting
Non Swaged Heater With Locating Ring
Non Swaged Heater With RTV Potting
Non Swaged Heater With Stainless Steel NPT
Non Swaged Heater
Standard Construction Non Swaged Heater
Non Swaged Heater With 3 Zone Construction
Non Swaged Heater With 3 Zone Construction
Non Swaged Heater With Brass NPT
Non Swaged Heater With Epoxylite Potting
Non Swaged Heater With Locating Ring
Non Swaged Heater With RTV Potting
Non Swaged Heater With Stainless Steel NPT

Non-Swaged Cartridge Heaters

Non-swaged cartridge heaters offer a cost effective solution where the performance of a swaged cartridge heater is not required. Non-swaged cartridge heaters can be used at watt densities up to 45 watts per square inch and temperatures up to 1000°F. Non-swaged cartridgeheaters offer tighter length tolerances than swaged heaters. Non-swaged cartridge heaters can be built with 3 independent heat zones. Non-swaged heaters are not recommended for applications where there is a lot of vibration or impact.

Bookmark and Share Download Brochure

Non-Swaged Cartridge Heater Watt Density

Formula

Watt density is calculated with the following formula: 

Watt Density = Wattage / Heated Length x Diameter x 3.14

Clearance

Clearance is determined by taking the hole diameter and subtracting the heater diameter.

  • Cycling reduces heater life and high cycling applications should use lower numbers.
  • Staying below these values will result in increased heater life.

Non-Swaged Cartridge Heater Watt Density

Hole Clearance 1000* 800* 600* 400* 200*
0.003 25 30 35 40 45
0.005 20 25 30 35 45
0.010 20 23 28 30 38
0.015 18 20 25 27 34
0.030 16 15 20 23 30
0.100 10 12 15 20 25

*Block temperature in degrees Fahrenheit 

Back to Top