Mica Band Heater Fiberglass Lead Terminations

Type L1 leads

• Leads exiting both sides of gap are standard unless otherwise specified.
• High temperature fiberglass leads are rated to 850°F.
• Standard lead length is 10 inches.
• Minimum Diameter: 3/4 inch
• Minimum Width: 3/4 inch

Type L2 leads

• Leads exit 180° from the gap unless otherwise specified.
• 1.5" of sleeve protection is standard on lead exits.
• Minimum Diameter: 1 inch
• Minimum Width: 1 inch

Type L3 leads

• Leads exiting straight out the side are available on any construction.
• Leads exit through a brass eyelet.
• Minimum Diameter: 1.50 inch
• Minimum Width: 3/4 inch

Type L4 leads

• Leads may exit at right angle out of cap from any position on the heater.
• 1.5" of sleeve protection is standard.
• Minimum Diameter: 1.25 inch
• Minimum Width: 1 inch

Type L5 leads

• Lead wires on one side of gap are available on any construction.
• Common exit for small band heaters.
• Minimum Diameter: 1 inch
• Minimum Width: 1 inch

Type L6 leads

• Stainless steel spring provides extra support, protecting leads from sharp bends.
• Minimum Diameter: 1.50 inch
• Minimum Width: .75 inch